grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S line ...

[Dan] salvaged some parts from an old printer a while back and finally found some time to play with them. One of the things he was most interested in is the geared stepper motor seen above. He was ...

TRINAMIC Motion Control's new TMC2660 stepper motor driver IC supports motor drive currents up to 4A. The new IC integrates both a pre-driver for real-time calculation of motor coil current values, ...

I like this one – a super impressive Arduino-based barometer for measuring air pressure. There’s something satisfying about the link with nature, a tangible connection with outside weather. In a ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...